My boss got some new DTA systems in(stand alone engine control units) last week. Any rate..I have been pondering this for quite some time now since it cost\'s about $1300. Well, he decided to let me install it and I just pay some now..some later..etc. I start prepping all of the wires, sensors and connections to connect with a stock wire harness.
Well fast forward to today, I got on the dyno and started to tune the damn thing. Well..turns out I leaned the fuel out just a tad too much and now cylinders 2 and 3 are TOAST!(for the 3rd time)I did EVERYTHING in small increments and I have a built bottom end, so Im not really sure what has gone wrong as of yet. I only tore down the top half just to check if it was the pistons or not. Guess Ill find out more within the week.
I just basically wanted to vent somewhere.
Any donations are appreciated

(j/k)